Special pump factory professional sharing: three factors for determining the flow rate of high temperature heat transfer oil pump

Determination of the flow rate of the high temperature heat transfer oil pump:

a. If the minimum, normal, and maximum flow rates have been given in the high-temperature heat transfer oil pump production process, the maximum flow rate should be considered.

b. If only the normal flow rate is given in the production process of the high temperature heat transfer oil pump, consideration should be given to leaving a certain margin.

For high-flow low-lift high-temperature heat-conducting oil pump with ns>100, the flow residual is taken, for low-flow high-lift high-temperature heat-conducting oil pump with ns<50, the flow residual is 10%, 50≤ns≤100, high-temperature heat-conducting oil pump, flow remaining The amount is also 5%. For pumps with poor quality and poor operating conditions, the flow balance should be 10%.

c. If the basic data is only for weight flow, it should be converted into volume flow.

Although most high-temperature heat transfer oil pumps are always based on different usage environments, customers have increasingly demanded product life and efficiency. Our engineers are experienced experts in design, material selection and monitoring systems. In addition to the development of new designs, we often exchange experiences with our users, continually improve our existing technical level and provide the best design solutions for our customers' projects and projects.

MAGIK Lift Series are made of  PDO (Polydioxanone), it is a thread with no cones, thus no damage to the tissue. This is the same thread used in Cardiac and other surgeries as sutures, and thus it is very safe.

Aging causes the skin tissue to be thin because the collagen and elastin fibre`s break down, which results in sagging skin, deep creases, folds and wrinkles. PDO Thread reverses the effects of aging.
Threads are implanted into the sub-dermal skin and stimulate the production of collagen and the skin becomes firmer, elastic and moisturised. The thread dissolves itself in couple of months but the effect last for 12-18 months.
The thread can be applied to anywhere on the body, such as a flabby face, cheeks, eyebrows, to prevent eye bags, sagging neck skin, fine lines around Cheeks, angle around the mouth, laugh lines, forearm and abdomen, smokers lines and lifting of breast.

Polydioxanone

Medical Polydioxanone,Surgical Polydioxanone,Polydioxanone Monofilament,Thread Polydioxanone

Dermax Technology Limited , http://www.dermaxmed.com